Boltex Inertial is a medical device designed to tone and recondition women’s pelvic floor muscles. It has an exclusive and patented
design based on a set of hexagonal cells on the internal surface of the sphere, which give it extraordinary properties that help to provide effective stimulation of the pelvic floor mucles, regardless of its position after having been inserted into the vagina and of the user’s anatomical and morphological characteristics.
The efficiency of an inertial device lies in its capacity to tone the PFM.
The accelerometry graph shows the comparison between Boltex Inertial, in which the interior sphere knocks against the shell (Top graph) and an inertial device in which the interior sphere rolls instead of knocks (bottom graph, other models on the
market). After knocking, a vibration is produced, which leads to a reflex toning action in the perineal muscles.
1. INTERIOR BALL
Coated with silicone to prevent noise.
2. THE SPHEROID
It is made from PC/ABS, as this material is a good transmitter of vibration.
3. THE STRING
Makes it easier to extract from the vagina. It is made from TPE, which guarantees its medical quality and health and hygiene conditions.
Instructions for Use
- Treatment of stress urinary incontinence.
- Treatment of mixed urinary incontinence (Stress urinary incontinence and Urge urinary incontinence).
- Prevention after vaginal delivery.
- Prevention of pelvic organ prolapse in the menopause.
- Treatment of sexual dysfunction derived from lack of PFM tone (Reduction in sensitivity and intensity of orgasm).
- Pelvic surgery adjuvant therapy (pre- and post-operative).
- Prevention of loss of tone in women who practice physical activity and impact sports.
How to Use
Follow the instructions given by your health professional.
This device has been designed for use and application in women of any age and build.
As a general rule, follow the recommendations for use listed below:
1)Empty your bladder, if necessary.
2)Clean Boltex with warm water and mild soap.
3)Lubrication: Use a small amount of lubricating gel in case of vaginal dryness.
4)Insertion: Relax your pelvic muscles both for inserting and for removing the device. Bending one or both legs (squatting) can help insertion. Place your index or middle finger on the flat area of the sphere (situated between the removal strings) and push the sphere into the vaginal passage. Part of the string will remain outside the body to enable the device to be removed.
5)Exercising: Exercise your muscles by walking for an hour or the time specified by your doctor. If you do Kegel exercises as well as using Boltex, the benefits will be greater. As a general recommendation, start with 15 min/day exercises for 2 weeks. After 2 weeks, you can continue with 30-60 min. exercise sessions. During treatment, combine fast voluntary contractions (close anus
tightly) with slow contractions lasting 15-20 seconds. Boltex Inertial can be used every day. Improvement in muscle tone is usually noticeable after 6-8 weeks of use. Most women recover their muscle tone after 3-6 months, depending on their degree of initial
low muscle tone. Note: At first you may experience some muscular discomfort (cramps) from using Boltex Inertial. Should you experience any severe discomfort, see your doctor before continuing use.
6)Removal: Relax your muscles and use the string to pull out the device. Women suffering from stress urinary incontinence are advised to remove the device in the knee-chest position and with their muscles relaxed, as they have urinary bladder descent and this position makes it easier for them to remove the device in the first few weeks.
7)Cleaning: Clean the device before and after use with warm water and pH-neutral soap. Store it in its original case or bag to keep it in good condition and prevent contact with dust or other materials.